HP Elitebook 1040

3. Remove the audio jack (3) from the computer.
To install the audio jack, reverse this procedure.
Connector board cable
To remove the connector board cable, use this procedure and illustration.
NOTE: The connector board cable is included in the Cable Kit, spare part number N09040-001.
Before removing the connector board cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 38).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Disconnect the battery cable from the system board (see Battery on page 40).
Remove the connector board cable:
1. Release the ZIF connector (1) the connector board cable is connected to, and then disconnect the
cable from the system board.
2. Release the ZIF connector (2) the connector board cable is connected to, and then disconnect the
cable from the connector board.
Connector board cable
51