To install the fingerprint reader, reverse this procedure.
Fingerprint reader cable
To remove the fingerprint reader cable, use this procedure and illustration.
NOTE: The fingerprint reader cable is included in the Cable Kit, spare part number N09040-001.
Before removing the fingerprint reader cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 38).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Remove the battery (see Battery on page 40).
4. Remove the right speaker (see Speakers on page 45).
5. Remove the fingerprint reader (see Fingerprint reader on page 61).
Remove the fingerprint reader cable:
■
Release the ZIF connector (1) the fingerprint reader cable is connected to, and then disconnect the
fingerprint reader cable (2) from the fingerprint reader.
To install the fingerprint reader cable, reverse this procedure.
NFC module cable
To remove the NFC module cable, use this procedure and illustration.
NOTE: The NFC module cable is included in the Cable Kit, spare part number N09040-001.
Before removing the NFC module cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 38).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Remove the battery (see Battery on page 40).
Remove the NFC module cable:
1. Release the ZIF connector (1) the NFC module cable is connected to, and then disconnect the NFC
module cable from the system board.
Fingerprint reader cable
63
To Next Page
Loading...
