HP Elitebook 1040

2. Press down on the module until the side retention clips snap into place (3).
Solid-state drive
To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-7
Solid-state drive descriptions and part numbers
Description Spare part number
2 TB, M.2 2280, PCIe-4×4, ZTurbo solid-state drive with TLC M52027-001
1 TB, 2280, PCIe-4×4, NVMe solid-state drive with TLC M16560-001
1 TB, M.2 2280, PCIe-4×4, SED solid-state drive with TLC N23415-001
512 GB, 2280, PCIe-4×4, NVMe solid-state drive with TLC M17436-001
512 GB, M.2 2280, PCIe-4×4, NVMe solid-state drive N45476-001
512 GB, M.2 2280, PCIe-4×4, NVMe, value solid-state drive N04490-001
512 GB, M.2 2280, PCIe-4×4, SED solid-state drive with TLC M52031-001
256 GB, M.2 2280, PCIe-4×4, NVMe solid-state drive N45477-001
256 GB, M.2 2280, PCIe-4×4, NVMe, SED solid-state drive with TLC M35225-001
Solid-state drive shield: Included in the Bracket Kit, spare part number N09030-001. L85354-001
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 38).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Disconnect the battery cable from the system board (see Battery on page 40).
48
Chapter 5 Removal and replacement procedures for authorized service provider parts