4. Pull the drive (2) away from the socket to remove it.
To install a solid-state drive, reverse the removal procedures.
NOTE: Solid-state drives are designed with a notch to prevent incorrect insertion.
Audio jack
To remove the audio jack, use this procedure and illustration.
Table 5-8
Audio jack description and part number
Description Spare part number
Audio jack (includes cable) N11993-001
Before removing the audio jack, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 38).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Disconnect the battery cable from the system board (see Battery on page 40).
Remove the audio jack:
1. Remove the Phillips M2.0 × 2.5 screw (1) that secures the audio jack to the computer.
2. Release the zero insertion force (ZIF) connector (2) the audio jack cable is connected to, and then
disconnect the cable from the system board.
50
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
