3. Remove the bottom cover (3) from the computer.
4. Thoroughly clean the thermal material from the surfaces of the WWAN module and the bottom
cover each time the bottom cover is removed. Replacement thermal material is included with the
bottom cover spare part kit. The following illustration shows the replacement thermal material
locations.
A thermal pad is used on the WWAN module (1) and on the bottom cover area (2) that services it.
To replace the bottom cover, reverse the removal procedures.
Battery
To remove the battery, use this procedure and illustration.
40
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
