3. Remove the card reader cable (3) from the computer.
To install the card reader cable, reverse this procedure.
Card reader
To remove the card reader, use this procedure and illustration.
Table 5-17
Card reader description and part number
Description Spare part number
Card reader
NOTE: The card reader spare part kit does not include the card reader cable. The card reader cable
is included in the Cable Kit, spare part number N09040-001.
N02323-001
Before removing the card reader, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 38).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Remove the battery (see Battery on page 40).
4. Remove the card reader cable (see Card reader cable on page 67).
Remove the card reader:
1. Remove the three Phillips M2.0 × 2.5 broad head screws (1) that secure the card reader to the
computer.
68
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
