2. Remove the Phillips M2.0 × 2.5 screw (2), and then remove the WWAN module (3).
3. If the WWAN module antenna is not connected to the terminal on the WWAN module, install a
protective sleeve on the antenna connector, as shown in the following illustration.
To install the WWAN module, reverse the removal procedures.
WLAN module
To remove the WLAN module, use this procedure and illustration.
Table 5-4
WLAN module descriptions and part numbers
Description Spare part number
Intel AX211 Wi-Fi 6e + Bluetooth 5.2 M.2 2230 160 MHz CNVi WW WLAN module M53366-001
WLAN module 43
To Next Page
Loading...
