HP Elitebook 1040

2. Release the ZIF connector (2) the NFC module cable is connected to, and then disconnect the NFC
module cable from the NFC module.
3. Detach the NFC module cable (3) from the computer. The NFC module cable is attached to the top
cover/keyboard with double-sided adhesive.
4. Remove the NFC module cable.
To install the NFC module cable, reverse this procedure.
NFC module
To remove the NFC module, use this procedure and illustration.
Table 5-15
NFC module description and part number
Description Spare part number
NFC module
NOTE: The NFC module spare part kit does not include the NFC module cable. The NFC module
cable is included in the Cable Kit, spare part number N09040-001.
M08706-001
Before removing the NFC module, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 38).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Remove the battery (see Battery on page 40).
4. Remove the NFC module cable (see NFC module cable on page 63).
Remove the NFC module:
1. Release the ZIF connector (1) the NFC module cable is connected to, and then disconnect the NFC
module cable from the NFC module.
64
Chapter 5 Removal and replacement procedures for authorized service provider parts