● NFC module ZIF cable (13)
● RTC battery cable (14)
● Fingerprint reader ZIF cable (15)
9. Remove the following screws that secure the system board and the I/O bracket to the computer:
● Two Phillips M2.0 × 2.5 broad head screws (1)
● Three Phillips M2.0 × 4.5 screws (2)
● One Phillips M1.6 × 4.0 screw (3)
● Four Phillips M2.0 × 4.5 screws (4)
10. Remove the system board I/O bracket (5).
The system board I/O bracket is included in the Bracket Kit, spare part number N09030-001.
11. Lift the left side of the system board (1) until it rests at an angle.
System board
59
To Next Page
Loading...
