HP ENVY 16 - Fan Assembly Replacement

5. If the WLAN antenna is not connected to the terminal on the WLAN module, install a protective sleeve on
the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
Solid-state drive
To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-5
Solid-state drive descriptions and part numbers
Description Spare part number
2 T, M2 2280, PCIe-4 × 4, NVMe value, three-layer cell (TLC) M52027-005
1 T, M2 2280, PCIe-4 × 4, NVMe value, TLC M16560-005
512 GB, M2 2280 PCIe-4 × 4, NVMe value, TLC M17436-005
Solid-state drive thermal pad N13391-001
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 33).
2. Remove the bottom cover (see Bottom cover on page 33).
3. Remove the battery (see Battery on page 34).
Remove the solid-state drive:
1. Remove the two Phillips M2.0 × 2.5 screws (1) that secure each solid-state drive covers to the computer.
2. Lift and remove each solid-state drive cover (2).
Solid-state drive
39