2. Remove the heat sink from the computer (2).
3. Thoroughly clean the thermal material from the surfaces of the heat sink and the system board
components each time the heat sink is removed. Replacement thermal material is included with the heat
sink, system board and all other related parts. The following illustration shows the replacement thermal
material locations.
Thermal grease (1) and thermal gel (2) are used on the system board components and on the heat sink
areas that service them.
Reverse this procedure to install the heat sink.
Fan assembly
To remove the fan, use this procedure and illustration.
Table 5-7
Fan description and part number
Description Spare part number
Fan CPU (60 W models) N13387-001
Fan assembly 41
To Next Page
Loading...
