HP ENVY 16 - Display Assembly Removal

3. Remove the hall sensor board (3).
Reverse this procedure to install thehall sensor board.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table 5-14
Touchpad description and part number
Description Spare part number
Touchpad N13371-001
Touchpad cable N13375-001
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 33).
2. Remove the bottom cover (see Bottom cover on page 33).
3. Remove the battery (see Battery on page 34).
4. Remove the heat sink (see Heat sink on page 40).
5. Remove the fan (see Fan assembly on page 41).
6. Remove the display assembly panel (Display assembly panel on page 43).
7. Remove the system board (see System board on page 44).
Remove the touchpad:
1. Remove the four Phillips M2.0 × 2.5 screws (1) that secure the touchpad bracket to the computer and
then remove the bracket (2).
2. Remove the three Phillips M2.0 × 2.5 screws (3) that secure the touchpad to the computer.
Touchpad
51