HP ENVY 16 - Heat Sink

3. Remove each solid-state drive (3).
To install the solid-state drive, reverse the removal procedures.
NOTE: Solid-state drives are designed with a notch to prevent incorrect insertion. When installing, make
sure the thermal pad is attached to the solid-state drive covers before replacement.
Heat sink
To remove the heat sink, use these procedures and illustrations.
Table 5-6
Heat sink descriptions and part numbers
Description Spare part number
Heat sink for use in 80 W models N13390-001
Heat sink for use in 60 W models N13389-001
Thermal gel M81334-001
Thermal gel syringe M81335-001
Thermal grease kit M28157-001
Thermal grease syringe M28158-001
Before removing the heat sink, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 33).
2. Remove the bottom cover (see Bottom cover on page 33).
3. Remove the battery (see Battery on page 34).
Remove the heat sink:
1. In the order indicated on the heat sink, remove the four Phillips M2.0 × 3.5 screws (1) that secure the
heat sink to the computer.
40
Chapter 5Removal and replacement procedures for authorized service provider parts