To replace the speakers, reverse the removal procedures.
Solid-state drive
To remove the solid-state drive, use this procedure and illustration.
Table 5-4
Solid-state drive descriptions and part numbers
Description Spare part number
2 TB, M.2 2280, PCIe-4×4, ZTurbo solid-state drive with TLC M52027-005
1 TB, 2280, PCIe-4×4, NVMe, solid-state drive with TLC M16560-005
1 TB, M.2 2280, PCIe-4×4, NVMe, value solid-state drive N45474-005
1 TB, 2280, PCIe-4×4, NVMe, solid-state drive with TLC for use only in The People's Republic of China N77395-005
1 TB, 2280, PCIe-4×4, NVMe, value solid-state drive for use only in The People's Republic of China N77394-005
512 GB, 2280, PCIe-4×4, NVMe, solid-state drive with TLC M17436-005
512 GB, M.2 2280, PCIe-4×4, NVMe, solid-state drive N45476-005
Solid-State Drive Thermal Pad Kit N91032-001
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 31).
2. Remove the bottom cover (see Bottom cover on page 31).
3. Disconnect the battery cable from the computer (see Battery on page 33).
Remove the solid-state drive:
1. Remove the two Phillips M2.0 × 3.9 screws (1) that secure the solid-state drive and shield to the
computer.
2. Remove the heat sink shield (2).
3. Lift the edge of the solid-state drive (3) opposite the slot until it rests at an angle.
Solid-state drive
35
To Next Page
Loading...
