6. Remove the fan (7) by sliding it up and forward at an angle.
To replace the fan, reverse the removal procedures.
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
The display assembly is available only at the the subcomponent level. Subcomponent level spare part
information is available in the subcomponent level disassembly subsection.
Before removing the display assembly, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 31).
2. Remove the bottom cover (see Bottom cover on page 31).
3. Disconnect the battery cable from the computer (see Battery on page 33).
Remove the display assembly:
1. Release the ZIF connector (1) the display panel cable is connected to, and then disconnect the
display panel cable from the system board.
2. Release the ZIF connector (2) the OLED board cable is connected to, and then disconnect the OLED
board cable from the system board (select products only).
Display assembly
43
To Next Page
Loading...
