2. Remove the audio jack board (2) from the computer.
To replace the audio jack board, reverse the removal procedures.
Fan
To remove the fan, use these procedures and illustrations.
Table 5-9
Fan description and part number
Description Spare part number
Fan (includes cable) N91030-001
Before removing the fan, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 31).
2. Remove the bottom cover (see Bottom cover on page 31).
3. Disconnect the battery cable from the computer (see Battery on page 33).
Remove the fan:
1. Release the ZIF connector (1) the display panel cable is connected to, and then disconnect the
display panel cable from the system board.
2. Release the audio jack board cable (2) and the display panel cable from the retention clips (3) that
are built into the fan.
3. Disconnect the fan cable (4) from the system board.
4. Remove the three Philllips M2.0 × 3.9 screws (5) that secure the fan to the computer.
5. Lift the front edge of the fan (6) until it rests at an angle.
42
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
