Before removing the touchpad cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 31).
2. Remove the bottom cover (see Bottom cover on page 31).
3. Remove the battery (see Battery on page 33).
Remove the touchpad cable:
1. Release the ZIF connector (1) the touchpad cable is connected to, and then disconnect the
touchpad cable from the system board.
2. Release the ZIF connector (2) the touchpad cable is connected to, and then disconnect the
touchpad cable from the touchpad.
3. Detach the touchpad cable (3) from the computer. The touchpad cable is attached to the computer
with double-sided adhesive.
4. Remove the touchpad cable.
To replace the touchpad cable, reverse the removal procedures.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table 5-15
Touchpad descriptions and part numbers
Description Spare part number
In atmospheric blue finish N91028-001
In meteor silver finish N91029-001
NOTE: The touchpad spare part kit does not include the touchpad bracket or the touchpad cable. The touchpad bracket is not
available as a spare part. The touchpad cable is available using spare part number N91027-001.
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 31).
Touchpad
59
To Next Page
Loading...
