3. Release the display panel cable from the retention clips (3) that are built into the fan.
4. Release the ZIF connector (1) the webcam/microphone module cable is connected to, and then
disconnect the webcam/microphone module cable from the system board.
5. Remove the WLAN module shield (2) that secures the WLAN antenna cables to the WLAN module..
NOTE: The WLAN module shield is available using spare part number N10779-001..
6. Carefully disconnect the WLAN antenna cables (3) from the terminals on the WLAN module.
NOTE: Computer models have either one or two WLAN antennas. On models with two antennas,
the #1 WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2 WLAN antenna
cable connects to the WLAN module #2 Aux terminal.
44
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
