7. Remove the six Phillips M2.5 × 5.5 screws that secure the display assembly to the computer.
8. Swing the front edge of the display assembly (1) down and away from the top cover and keyboard
until it rests at a 90-degree angle.
9. Release the display hinges from the top cover by sliding the display assembly (2) straight back.
10. Separate the top cover and keyboard (3) from the display assembly.
11. To remove the display panel assembly and access the display assembly internal components:
When replacing the display panel assembly, be sure to update the touch firmware, available on the
http://www.hp.com/support page.
a. Install suction cups (1) on the display panel and the display back cover, slightly below and to the
right of the webcam location.
b. Use the suction cups to carefully separate the display panel assembly (2) from the display
back cover.
Display assembly
45
To Next Page
Loading...
