The touch control board is available using spare part number N91004-001.
15. To remove the wireless antenna cables and transceivers:
a. Remove the display panel assembly.
b. Release the wireless antenna cables from the retention clips (1) and routing channels that are
built into the display back cover.
c. Detach the wireless antenna transceivers (2) from the display back cover. The wireless
antenna transceivers are attached to the display back cover with double-sided adhesive.
d. Remove the wireless antenna cables and transceivers.
The wireless antennas are available using spare part numbers N91035-001 (for use on
computer models equipped with a display panel assembly with 400 nits typical brightness)
and N91034-001 (for use on computer models equipped with a display panel assembly with
300 nits typical brightness).
16. To remove the hinges and hinge covers:
Display assembly
51
To Next Page
Loading...
