HP FlexFabric 5700 series User Manual

161
# Configure the BAS-IP as 20.20.20.1 for portal packets sent from VLAN-interface 4 to the portal
authentication server.
[SwitchA–Vlan-interface4] portal bas-ip 20.20.20.1
[SwitchA–Vlan-interface4] quit
On Switch B, configure a default route to subnet 192.168.0.0/24, specifying the next hop address as
20.20.20.1. (Details not shown.)
Verifying the configuration
# Verify that the portal configuration has taken effect.
[SwitchA] display portal interface vlan-interface 4
Portal information of Vlan-interface4
Nas id profile: Not configured
IPv4:
Portal status: Enabled
Authentication type: Layer3
Portal Web server: newpt
Authentication domain: Not configured
Bas-ip: 20.20.20.1
User Detection: Not configured
Action for server detection:
Server type Server name Action
-- -- --
Layer3 source network:
IP address Mask
Destination authenticate subnet:
IP address Mask
IPv6:
Portal status: Disabled
Authentication type: Disabled
Portal Web server: Not configured
Authentication domain: Not configured
Bas-ipv6: Not configured
User detection: Not configured
Action for server detection:
Server type Server name Action
-- -- --
Layer3 source network:
IP address Prefix length
Destination authenticate subnet:
IP address Prefix length
Before a user performs portal authentication by using the HP iNode client, the user can access only the
authentication page http://192.168.0.111:8080/portal. All Web requests the user initiates will be
redirected to the authentication page.
• If the user passes the authentication but fails the security check, the user can access only the
resources that match ACL 3000.

HP FlexFabric 5700 series Specifications

General

Layer Support	L2/L3
Routing Protocol	OSPF, BGP, RIP, IS-IS, Static Routing
Remote Management Protocol	SNMP, CLI, Web
Features	VXLAN
Compliant Standards	IEEE 802.1D, 802.1Q, 802.1w, 802.1s, 802.3ad
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (non-condensing)
VLANs	4K