The command interpreter input file (CIIN) is automatically invoked after the first processor is
loaded. The CIIN file shipped with new systems contains the TACL RELOAD * command, which
loads the remaining processors.
Default Naming Conventions
With a few exceptions, default naming conventions are not necessary for system resources.
However, default naming conventions have been preconfigured for the following resources to
simplify initial configuration files and automatic generation of these resources.
DescriptionExampleNaming Convention
1
Type of Object
Twentieth ESS disk drive in
the system
$ESS20$ESS numberESS disk drive
Twentieth SAS disk volume
in the system
$SAS20$SASnumberSAS disk enclosure
First modular tape drive in
the system
$TAPE01$TAPE numberModular tape drive
IP CLIM which has the X1
attachment point to the VIO
N100241N group module slot
port
IP CLIM
enclosure located in group
100, module 2, slot 4, port
1
Telco CLIM which has the
X1 attachment point to the
O100243O group module slot
port
Telco CLIM
VIO enclosure located in
group 100, module 2, slot 4,
port 3
Storage CLIM which has the
X1 attachment point to the
S100233S group module slot
port
Storage CLIM
VIO enclosure located in
group 100, module 2, slot 3,
port 3
Ethernet connection in
location 100.2.7
G10027G group module slotEthernet Adapter object
Logical interface (LIF) for
PIF B in slot 7 in module 2
L10027BL group module slot
PIF
Ethernet LIF object
of the Group 100 VIO
Enclosure
First TCP6SAM or TCP/IP
process for the system
$ZTC0$ZTC numberTCP/IP process
First Telserv process for the
system
$ZTN0$ZTN numberTelserv process
First Listener process for
the system
LSN0$LSN numberListener process
NoneNoneAutomatically created by
WANMGR
TFTP process
NoneNoneAutomatically created by
WANMGR
WANBOOT process
Tenth SWAN/SWAN 2
concentrator in the system
S10S numberSWAN/SWAN 2
concentrators
62 Default Startup Characteristics and Naming Conventions
To Next Page
Loading...
Need help?
General