HP Integrity rx1620

If the LOG_LEVEL variable in the sstk.conf file is set to 0 (zero), addition information is added
to the log file as indicated in the following example:
============== lspci ==============
<output of the lspci command>
============== dmesg ==============
<output of the dmesg command>
============== hpbmc ==============
<output of the hpbmc utility>
============== dumppci ==============
<output of the dumppci utility>
============== hpia64info ==============
<output of the hpia64info utility>
============== /proc/partitions ==============
<output of the /proc/partitions file>
============== hwdisc ==============
<output of the hwdisc utility>
Troubleshooting 21