HP Integrity rx1620 Deployment Guide

Table 5-6 Automatic script file options (continued)
ValueOption
Specifies the Write Cache percentage. This option is not required. If this option
is not specified, the Read/Write cache ratio will remain unchanged.
This value is a numeric value from 0 to 100. It must form a valid read/write cache
ratio that is supported on the controller with the ReadCache option.
WriteCache
Specifies the Rebuild Priority. This option is not required. If this option is not
specified, the Rebuild Priority will remain unchanged.
• Low
• Medium
• High
RebuildPriority
Specifies the Expand Priority. This option is not required. If this option is not
specified, the Expand Priority will remain unchanged.
• Low
• Medium
• High
ExpandPriority
Specifies the Surface Scan Delay in seconds. This option is not required. If this
option is not specified, the Surface Scan Delay will remain unchanged.
N: This value is a numeric value between 1 and 30 seconds.
SurfaceScanDelay
Specifies if Automatic Configuration should attempt to add spares. This option
is not required. This option is ignored in Reconfigure mode if there is an existing
configuration on the controller. In this case, the configuration suggester makes
spare decisions based on the existing configuration.
• Yes: Automatic Configuration attempts to add spares to each array. This is
the default value for the OnlineSpare option if it is not specified.
• No: Automatic Configuration does not add spares to each array.
OnlineSpare
Specifies the RAID level that Automatic Configuration uses. It is not required. If
the RAID option is not specified or the specified RAID option is not possible, the
default RAID is the highest RAID level that is supported with the current state
of the controller. This option is ignored in Reconfigure mode if there is an existing
configuration on the controller. In this case, the configuration suggester makes
RAID decisions based on the existing configuration.
• ADG: RAID ADG is equivalent to RAID 6
• 6: RAID 6
• 5: RAID 5
• 4: RAID 4
• 1: RAID 1
• 0: RAID 0
RAID
Custom script file format
The custom script is used to apply custom configurations to unconfigured or configured
controllers. You can specify exactly the configuration needed.
The following is a custom script file syntax:
The following is a custom script file syntax:
Action = Configure|Reconfigure
Method = Custom
; Controller Options
; There can be multiple controller specifications in the file
Controller = All|Slot [N][:N]|WWN [N]| First |
SerialNumber [N]|
IOCabinet [N],IOBay [N],IOChassis [N],
72 Utilities Reference

HP Integrity rx1620 Specifications

General

Brand	HP
Model	Integrity rx1620
Category	Server
Language	English