HP Integrity rx1620 Deployment Guide

Table 5-7 Custom script file options (continued)
ValueOption
Specifies the Max Boot setting (Sectors Per Track) for the logical drive. The Sectors
option is not required. If the logical drive is new, the default is 32. If the logical
drive already exists, then the default is the current Sectors setting on the logical
drive.
• 32: Disable Max Boot (32 sectors per track).
• 63: Enable Max Boot (63 sectors per track).
Sectors
Specifies the Stripe Size for the logical drive in KB. In Configure mode, the Stripe
Size is the Stripe Size for the new logical drive. In Reconfigure mode, if the logical
drive already exists and the Stripe Size is different than the existing Stripe Size on
the logical drive, the cpqacuxe utility attempts to migrate the logical drive to the
specified Stripe Size. The Stripe Size option is not required. If the Stripe Size is not
specified for a new logical drive, the Stripe Size is the default Stripe Size for the
RAID level of the logical drive. If the Stripe Size is not specified for an existing
logical drive in Reconfigure mode and the user is not migrating the RAID, then the
current Stripe Size setting remains unchanged.
The following Stripe Size values are available:
• 8: 8 KB
• 16: 16 KB
• 32: 32 KB
• 64: 64 KB
• 256: 256 KB
• 512: 512 KB
The following Stripe Size values are available for RAIDS:
• RAID 0: 8, 16, 32, 64, 128, 256 (default is 128)
• RAID 1: 8, 16, 32, 64, 128, 256 (default is 128)
• RAID 4: 8, 16, 32, 64 (default is 16)
• RAID 5: 8, 16, 32, 64 (default is 16)
• RAID ADG: 8, 16, 32, 64 (default is 16)
StripeSize
Specifies the Array Accelerator setting for the logical drive.
• Enable: Enables the Array Accelerator for the logical drive. This is the default
setting for new logical drives.
• Disable: Disables the Array Accelerator for the logical drive.
ArrayAccelerator
Specifies that this logical drive should be a snapshot resource volume and specifies
the owner logical drive ID. If this command is not specified, the logical drive will
be a normal data volume.
N: This value is the logical drive ID of an existing logical drive which owns this
snapshot resource volume.
ResourceVolumeOwner
Specifies the SSP State for a logical drive. This command is only valid for controllers
that support SSP that is enabled/disabled on a logical drive basis. This option is not
required. If this option is not specified, the SSP State remains unchanged for existing
logical drives and is disabled for new logical drives. Currently, only the RA4x00
controller supports SSP that is enabled/disabled on a logical drive basis. For other
controllers that support SSP, see the SSPState command.
• Enable: Enables SSP for the logical drive.
• Disable: Disables SSP for the logical drive.
LogicalDriveSSPState
Specifies the SSP adapters that have access to a logical drive. This command is only
valid for controllers that support SSP. This option is processed only if the SSPState
or LogicalDriveSSPState is set to Enable. Otherwise, this command is ignored.
• [N],[N]…: A comma separated list of SSP adapter IDs that are granted access
to the logical drive.
• None: No SSP adapters are granted access to the logical drive.
SSPAdaptersWithAccess
cpqacuxe 77

HP Integrity rx1620 Specifications

General

Brand	HP
Model	Integrity rx1620
Category	Server
Language	English