HP Integrity rx1620 Deployment Guide

Table 5-8 cpqacuxe Error Codes (continued)
ReasonErrorCode
The entered Raid Array ID is invalid. The Raid Array ID can
only consist of the following characters: a-z, A-Z, 0-9, ! @ # * ( ) ,
- _ + : . / [space]. It cannot end with a space character or exceed
the maximum number of characters allowed by the controller.
Invalid Raid Array ID
2851
The controller does not support SSP.
Controller does not support
SSP
1091
The Controller does not support Logical Drive SSP states. Use
SSPState controller command to set the Controller SSP state.
Controller does not support
Logical Drive SSP states.
Use 'SSPState' Controller
command to set the
Controller SSP state
2855
Controller does not support Controller SSP state. Use
LogicalDriveSSPState logical drive command to set SSP
states for each Logical Drive.
Controller does not support
Controller SSP state. Use
'LogicalDriveSSPState'
Logical Drive command to set
SSP states for each Logical
Drive
2856
The SSP settings cannot be changed for the controller or logical
drive.
Cannot change SSP settings
2853
The adapter ID is not a valid adapter ID that was detected by
the controller.
Invalid SSP Adapter ID
2854
The requested SSP State is not a valid SSP state.
Invalid SSP State
2852
The controller does not support the snapshot resource volume
feature.
Controller does not support
snapshot resource volume
feature
2858
The specified Resource Volume Owner is not valid. The Resource
Volume Owner should be a valid existing logical drive ID.
Invalid Resource Volume
Owner
2859
The Resource Volume owner cannot be changed if it is a
configured logical drive.
Cannot change Resource
Volume Owner
2860
The controller is not redundant or does not support redundancy
settings.
Controller does not support
redundancy settings
2861
The preferred path mode is not a valid preferred path mode or
the controller is not available.
Invalid Preferred Path Mode
2864
The preferred path specified is not a valid chassis-slot for an
available active controller or the controller is not available.
Invalid Preferred Path
2865
Invalid Physical Drive count. A possible reason is that more disks
were requested than available of the current DriveType.
Invalid Physical Drive Count
2876
No suitable Spares available.
No Spares Available
2877
Spares are not supported in RAID0-only Arrays.
Spare Request for RAID0 is
Invalid
2878
Mode is Reconfigure and a controller reset with data loss was
specified.
Reset and Reconfigure
combined Error
2879
Invalid Disk Type specified.
Invalid Drive Type Specified
2880
An internal ACU error has occurred. This error should never
occur. If it does, there is a problem with ACU, and some error is
not being identified properly.
Internal Error
516
82 Utilities Reference

HP Integrity rx1620 Specifications

General

Brand	HP
Model	Integrity rx1620
Category	Server
Language	English