HP Intelligent PDU Service Menu 63
3.
On the session screen, the POST executes, and then a prompt appears. Press any key within 5
seconds to enter the HP Intelligent PDU Service Menu.
For more information about the POST, see "POST (on page 63)."
For more information about the Service Menu, see "Service Menu (on page 64)."
POST
When the iPDU is powered up or reset, the bootloader will perform a POST and output the following:
If any error is detected in the boot process, the Core Unit LED indicator illuminates or flashes (on page
87).
Navigating the menus
After you have successfully initiated a terminal emulation or telnet session, the HP Intelligent PDU Service
Menu (on page 64) appears.
• Open a submenu by entering the corresponding option number at the prompt.
• To enter or change configuration information, follow the onscreen prompts.
• Enter 0 at the submenu prompt to go to the previous menu.
-or-
Enter 0 at the Main menu prompt to exit the utility.
• Press the Enter key to refresh the screen.
• The iPDU resets automatically to allow configuration changes to take effect.
To Next Page
Loading...
Need help?
General
