Using Your hp iPAQ h2200 Series
Reference Guide 1–17
DRAFT - Revised 10/16/02
hp CONFIDENTIAL 12/3/02
File: ch1-UsingtheH2200.fm PN: 293146-001
Ä
CAUTION: The battery door must be tightly latched in order to
power the battery.
5. Activate the h2200 Series by inserting the stylus into the reset
button on the back for about two seconds. (CHECK AGAIN)
✎
The iPAQ h2200 Series will power on once the battery has been
inserted and the unit has been reset. However, if the battery is not
fully charged, you must connect the AC adapter to the h2200 unit
to fully charge it before continuing further. It takes about four
hours to fully charge it.
Ä
CAUTION: Because most of the applications and data you install on
your iPAQ h2200 Series are held in memory (RAM), you will need to
reinstall them if the battery completely discharges or if the battery is
removed from the unit for extended periods of time. Applications and
data installed in the iPAQ File Store folder are saved in ROM and will
not have to be reinstalled.
Charging the Battery
The iPAQ h2200 battery needs to be fully charged before setting
it up, and recharged regularly as your iPAQ h2200 Series uses
some power to maintain files in RAM and the clock. While
working at your desk, keep the iPAQ h2200 Series connected to
the AC adapter. When traveling, carry the AC adapter and charger
adapter plug with you.
Your iPAQ h2200 Series is shipped with a partial charge on the
battery. You may want to ensure that it is fully charged before
synchronizing.
To Next Page
Loading...
