ENWW The HP Jetdirect Control Panel Menu 282
CFG LINK= (10/100Base-TX print servers only) Selects whether you want to
manually configure the HP Jetdirect print server’s network link.
NO (default): Bypass the link configuration menu items.
YES: Access the link configuration menu items.
For 10/100Base-TX networks, the link speed and communication
mode must match the network. One of the following link
configurations can be set:
AUTO (default): The print server will automatically configure itself
to match the network’s link speed and communication mode.
If it fails, 100TX Half will be set.
10T HALF: 10Mbps, half-duplex operation
10T FULL: 10 Mbps, full-duplex operation
100TX HALF: 100 Mbps, half-duplex operation
100TX FULL: 100 Mbps, full-duplex operation
WEB= For configuration management, specify whether the embedded
Web server will accept communications using HTTPS (Secure
HTTP) only, or both HTTP and HTTPS.
HTTPS: For secure, encrypted communications, only HTTPS
access is accepted. The print server will appear as a secure
site.
HTTP/HTTPS: Access using either HTTP or HTTPS is permitted.
SECURITY= Specify whether the current security settings on the print server
will be saved or reset to factory defaults.
KEEP (default): The current security settings are maintained.
RESET: Security settings are reset to factory defaults.
Table C.1 HP Jetdirect Classic Control Panel Menu (6 of 6)
Menu Item Description
To Next Page
Loading...
