HP jetdirect 175x - Page 62

ENWW TCP/IP Configuration 62
MFP-config:
Enable or disable print server support of the client software provided with your
multifunction or all-in-one peripheral.
0 (default): disables client software support (allows printing only).
1: enables client software support (allows printing and scanning).
usb-mode:
Specifies the communication mode over the USB port on the HP Jetdirect print
server.
● Auto (default): Automatically negotiates and sets the the highest
communication mode possible for the attached printer or device.
● MLC: (Multiple Logical Channels) An HP-proprietary communication mode that
allows multiple channels of simultaneous print, scan and status
communications.
● BIDIR: A standard connection that supports bi-directional communications
between the printer and print server. The print server sends print data and
receives status from the printer.
● UNIDIR: A standard connection in which data is transferred in one direction
only (to the printer).
status-page-lang:
Specifies the page description language (PDL) that the print server will use to send
the Jetdirect configuration/status page to the printer.
● Auto (default): The PDL is auto-detected when the print server is powered on
or after a cold-reset.
● PCL: Hewlett-Packard Printer Control Language
● ASCII: Standard ascii characters
● HPGL2: Hewlett-Packard Graphics Language (v2)
● PS: Postscript language
Table 3.3 TFTP Configuration File Parameters (9 of 10)