ENWW TCP/IP Configuration 79
To set configuration parameters, you must set up a Telnet session
from your system to the HP Jetdirect print server.
1. Type the following at the system prompt:
telnet <IP address>
where <IP address> is the IP address listed on the Jetdirect
configuration page. See Chapter 9
.
2. A connection to the HP Jetdirect print server will be displayed.
If the server responds with “connected to IP address”, press
Enter twice to make sure that the Telnet connection is
initialized.
3. If prompted for a user name and password, enter the correct
values.
By default, the Telnet interface does not require a user name or
password. If an administrator password has been set, you will
be prompted for a user name and this password before you can
enter and save Telnet command settings.
4. By default, a Command Line interface is provided. To configure
parameters using a Menu interface, enter Menu. For more
information, see “User Interface Options
”.
For a list of supported commands and parameters, see “Telnet
Commands and Parameters”.
User Interface Options
The HP Jetdirect print server provides two interface options to
enter Telnet commands: a Command Line Interface (Default)
and
a Menu Interface
.
To Next Page
Loading...
