Check the error-correction settings
Usually, the printer monitors the signals on the telephone line while it is sending or receiving a fax. If the
printer detects an error during the transmission and the error-correction setting is On, the printer can request
that the portion of the fax be resent. The factory-set default for error correction is On.
You should turn off error correction only if you are having trouble sending or receiving a fax, and you are
willing to accept the errors in the transmission. Turning off the setting might be useful when you are trying to
send a fax overseas or receive one from overseas, or if you are using a satellite telephone connection.
NOTE: The steps vary according to the type of control panel.
1 2
1 2-line control panel
2 Touchscreen control panel
2-line control panels
1. On the printer control panel, press the Setup
button.
2. Open the following menus:
●
Fax Setup
●
All Faxes
●
Error Correction
3. Select On.
Touchscreen control panels
1. From the Home screen on the printer control panel, swipe until the Setup menu displays. Touch the
Setup
icon to open the menu.
2. Open the following menus:
●
Service
●
Fax Service
●
Error Correction
3. Touch the menu.
4. Touch the On button.
176 Chapter 9 Solve problems ENWW
To Next Page
Loading...