Load the Main input tray
Introduction
The following information describes how to load paper in the Main input tray. This tray holds up to 250
sheets of 75 g/m
2
(20 lb) paper.
NOTE: To avoid paper jams:
●
Never add or remove paper from the Main input tray during printing.
●
Before loading the tray, remove all of the paper from the input tray and straighten the stack.
●
When loading the tray, do not fan the paper.
●
Use paper that is not wrinkled, folded, or damaged.
1. Open the Main input tray door by grasping the
handle and pulling down.
O
K
2. Adjust the paper-width guides by squeezing the
adjustment latch on the right guide and sliding
the guides to the size of the paper being used.
ENWW Load the Main input tray 19
To Next Page
Loading...