To Next PageTo Next Page
What to do if both disk drive module LEDs are off on HP Network Hardware (Online/Activity and Fault/UID)?
This usually means there is no power to the disk, the disk is offline, or the disk is not configured. Check that the disk drive is fully inserted and latched in place, and that the enclosure is powered on.
Details the different form factors and controller types for MSA 2040 storage models.
Describes LEDs and components on the front and rear panels of enclosures and controller modules.
Identifies rear panel components for SAN and SAS controller modules.
Outlines installation tasks, cabling, and initial configuration procedures.
Details host system requirements, direct attach, and switch attach configurations.
Explains Fibre Channel, iSCSI, and SAS protocols, their ports, and usage.
Covers connecting systems for replication and managing host ports.
Explains SAN controller rear panel LEDs for FC, iSCSI, and network ports.
Details SAS controller rear panel LEDs for SAS ports, status, and cache.
General