HP MSA 2040 User Manual

Obtaining IP values 47
3. Enable the CLI port for subsequent communication:
• Linux customers should enter the command syntax provided in "Preparing a Linux computer before
cabling to the CLI port" (page 45).
• Windows customers should locate the downloaded device driver described in "Downloading a
device driver for Windows computers" (page 45), and follow the instructions provided for proper
installation.
4. Start and configure a terminal emulator, such as HyperTerminal or VT-100, using the display settings in
Table 2 and the connection settings in Table 3 (also, see the note following this procedure).
.
1
Your server or laptop configuration determines which COM port is used for Disk Array USB Port.
2
Verify the appropriate COM port for use with the CLI.
5. In the terminal emulator, connect to controller A.
6. Press Enter to display the CLI prompt (#).
The CLI displays the system version, MC version, and login prompt:
a. At the login prompt, enter the default user manage.
b. Enter the default password !manage.
If the default user or password—or both—have been changed for security reasons, enter the secure
login credentials instead of the defaults shown above.
NOTE: The following CLI commands enable you to set the management mode to v3 or v2:
•Use
set protocols to change the default management mode.
•Use
set cli-parameters to change the current management mode for the CLI session.
The system defaults to v3 for new customers and v2 for existing users (see the CLI Reference Guide
for more information).
7. At the prompt, type the following command to set the values you obtained in step 1 for each network
port, first for controller A and then for controller B:
Table 2 Terminal emulator display settings
Parameter Value
Terminal emulation mode VT-100 or ANSI (for color support)
Font Terminal
Translations None
Columns 80
Table 3 Terminal emulator connection settings
Parameter Value
Connector COM3 (for example)
1, 2
Baud rate 115,200
Data bits 8
Parity None
Stop bits 1
Flow control None

HP MSA 2040 Specifications

General

Brand	HP
Model	MSA 2040
Category	Storage
Language	English