HP MSR Router Series Configuration Guide

Ste
p
Command
Remarks
13. (Optional.) Enable SHDSL line
probing.
shdsl line-probing enable
By default, SHDSL line probing is
enabled.
14. Configure the expected
bandwidth for the interface.
bandwidth bandwidth-value
By default, the expected bandwidth
(in kbps) is calculated with the
following formula: Interface baud
rate/1000.
15. Configure an MTU value for the
interface.
mtu size
By default, the MTU value for the
interface is 1500 bytes.
16. (Optional.) Restore the default
of the interface.
default N/A
17. Bring up the interface.
undo shutdown
By default, the interface is up.
Configuring an EFM subinterface
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Create an EFM
subinterface and enter its
view.
interface efm
interface-number.subnumber
By default, no EFM subinterface is
created.
3. Configure the subinterface
description.
description text
By default, the description is
interface-name Interface.
4. Configure the expected
bandwidth for the
subinterface.
bandwidth bandwidth-value
By default, the expected bandwidth
(in kbps) is calculated with the
following formula: Interface baud
rate/1000.
5. Configure an MTU value
for the subinterface.
mtu size
By default, the MTU value for the
subinterface is 1500 bytes.
6. Restore the default of the
interface.
default N/A
7. Bring up the subinterface.
undo shutdown By default, the subinterface is up.
Displaying and maintaining ATM interfaces
Execute display commands in any view and reset commands in user view.
Task Command
Display information about an ATM
interface.
display interface [ atm [ interface-number ] ] [ brief [ description |
down ] ]
Display information about an EFM
interface.
display interface [ efm [ interface-number ] ] [ brief [ description |
down ] ]
Display DSL configuration
information.
display dsl configuration interface atm interface-number
65

HP MSR Router Series Specifications

General

Brand	HP
Model	MSR Router Series
Category	Network Router
Language	English