HP ntegrity iLO 2 MP User Manual

cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
Target: map1/enetport1/lanendpt1/ipendpt1
The ipendpt1 target represents the iLO IP endpoint settings.
Table 6-43 shows ipendpt1 target properties.
Table 6-43 ipendpt1 Properties
Access and ValuesDescriptionProperty Name
Read/write
The value of the property must be expressed
in dotted decimal notation.
iLO 2 MP IP address.IPv4Address
Read/write
The value of the property must be expressed
in dotted decimal notation.
iLO 2 MP subnet mask.SubnetMask
Read-only
The following are valid values:
Static: The iLO 2 MP IP address and subnet
mask were assigned statically.
DHCP: The iLO 2 MP IP address and subnet
mask were acquired using DHCP.
Used to indicate the configuration
method that resulted in the
configuration being assigned to this
ipendpt.
AddressOrigin
Verbs
cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
set Sets a property to a specific value.
Target: map1/dhcpendpt1
The dhcpendpt1 target represents the iLO 2 MP DHCP client.
Table 6-44 shows dhcpendpt1 target properties.
Table 6-44 dhcpendpt1 Properties
Access and ValuesDescriptionProperty Name
Read-only
The following are valid values:
Enabled: The iLO 2 MP DHCP client is enabled.
Disabled: The iLO 2 MP DHCP client is disabled.
Represents the state of iLO 2
MP DHCP.
EnabledState
Read-only
Set to DHCP.
Textual description of this
protocol endpoint.
OtherTypeDescription
Verbs
cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
start Enables iLO 2 MP DHCP.
stop Disables iLO 2 MP DHCP.
SMASH Server Management Command Line Protocol 139

HP ntegrity iLO 2 MP Specifications

General

Brand	HP
Model	ntegrity iLO 2 MP
Category	Server
Language	English