Verbs
show Displays information.
help Displays context-sensitive help.
set Sets a property to a specific value.
SM CLP vMedia Use Cases
The following examples show actions you can perform using SM CLP for vMedia.
Change the current context to the CD drive.
–> cd / map1 / oemhp_vm1 / cddr1
Show the current status to verify that the media is not in use.
–> show
Insert the desired image into the drive.
–> set / oemhp_image=http://my.imageserver.com/ISO/install_disk1.iso
Connect the media.
–> set / oemhp_connect=yes
Disconnect vMedia.
This command disconnects the media and clears the oemhp_image value.
–> set / map1 / oemhp_vm1 / cddr1 oemhp_connect=no
User Accounts Configuration
This section describes targets, their properties, and supported verbs used for configuring and
viewing iLO 2 MP user accounts using SM CLP.
Target: map1/group1
The group1 target represents a collection of user accounts on the iLO 2 MP.
Table 6-50 shows group1 target information.
Table 6-50 group1 Properties
Access and ValuesDescriptionProperty Name
Read-only
Set to collection of user accounts.
Textual description of this collection
target.
Description
Verbs
cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
Target: map1/group1/account#
The account# target represents a user account on this iLO 2 MP where # is the instance number
of the specific account. You can configure up to 19 user accounts on the iLO 2 MP.
Table 6-51 shows account# target properties.
Table 6-51 account# Properties
Access and ValuesDescriptionProperty Name
Read/write.
Specified in ASCII characters up to 24 characters long.
Login name of this user
account.
UserID
Read/write.
Specified in ASCII characters and must be least six characters long.
User password.UserPassword
SMASH Server Management Command Line Protocol 143
To Next Page
Loading...
