HP omnibook OmniBook XE2

2-14 Removal and Replacement HP OmniBook XE2
Reassembly Notes
• To resposition the inverter PCA, insert the plastic positioning knobs in the holes at each end of
the inverter.
• Wrap the cable and wires around screw holes and free of the edge of the display case.
• Slide the display bezel toward the top until it snaps in place.
• Start all of the bezel screws before tightening any of them.
• Note that the top screw covers differ from the bottom screw covers, and that the two screw covers
at the upper left and upper right are somewhat thicker than the others.