IPv6 Management Features
SNTP and Timep
For example, to configure link-local and global unicast SNTP server addresses
of:
■ fe80::215:60ff:fe7a:adc0 (on VLAN 10, configured on the switch)
■ 2001:db8::215:60ff:fe79:8980
as the priority “1” and “2” SNTP servers, respectively, using version 7, you
would enter these commands at the global config level, as shown below.
ProCurve(config)# sntp server priority 1
fe80::215:60ff:fe7a:adc0%vlan10 7
ProCurve(config)# sntp server priority 2
2001:db8::215:60ff:fe79:8980 7
Note In the preceding example, using a link-local address requires that you specify
the local scope for the address; VLAN 10 in this case. This is always indicated
by %vlan followed immediately (without spaces) by the VLAN identifier.
Syntax:. show sntp
Displays the current SNTP configuration, including the
following:
Time Sync Mode: Indicates whether timesync is disabled or set
to either SNTP or Timep. (Default: timep)
SNTP Mode: Indicates whether SNTP uses the broadcast or
unicast method of contacting a time server. The broadcast
option does not require you to configure a time server address.
The unicast option does require configuration of a time server
address.
Poll Interval: Indicates the interval between consecutive time
requests to an SNTP server.
Priority: Indicates the configured priority for the corresponding
SNTP server address.
SNTP Server Address: Lists the currently configured SNTP
server addresses.
Protocol Version: Lists the SNTP server protocol version to
expect from the server at the corresponding address.
5-11
To Next Page
Loading...
