Multicast Listener Discovery (MLD) Snooping
Configuring MLD
For example, to disable fast leave on ports in VLAN 8:
ProCurve(vlan-8)# no ipv6 mld fastleave a14-a15
To enable fast leave on ports in VLAN 8:
ProCurve(vlan-8)# ipv6 mld fastleave a14-a15
Configuring Forced Fast Leave
Syntax: [no] ipv6 mld forcedfastleave <port-list>
Note: This command must be issued in a VLAN context.
This command enables the forced fast leave function on the
specified ports in a VLAN.
The [no] form of the command disables the forced fast leave
function on the specified ports in a VLAN.
The forced fast leave function is disabled by default.
For example, to enable forced fast leave on ports in VLAN 8:
ProCurve(vlan-8)# ipv6 mld forcedfastleave a19-a20
To disable forced fast leave on ports in VLAN 8:
ProCurve(vlan-8)# no ipv6 mld forcedfastleave a19-a20
7-11
To Next Page
Loading...
