To Next Page

To Previous Page

IPv6 Diagnostic and Troubleshooting

DNS Resolver for IPv6

been configured as the domain name on the switch and the address of a DNS

server residing in that domain is also configured on the switch. The commands

for these steps are as follows:

ProCurve(config)# ip dns server priority 1 2001:db8::127:10

ProCurve(config)# ip dns domain-name mygroup.procurve.net

ProCurve(config)# ping6 mars-1

fe80::215:60ff:fe7a:adc0 is alive, time = 1 ms

Figure 8-3. Example of Configuring for a Local DNS Server and Pinging a Registered Device

However, for the same “mars-1” device, if mygroup.procurve.net was not the

configured domain name, you would have to use the fully qualified domain

name for the device named mars-1:

ProCurve# ping6 mars-1.mygroup.procurve.net

For further information and examples on using the DNS feature, refer to “DNS

Resolver” in appendix C, “Troubleshooting”, in the current Management and

Configuration Guide for your switch.

Viewing the Current Configuration

Use the show ip dns command to view the current DNS server configuration.

Use the show run command to view both the current DNS server addresses

and the current DNS domain name in the active configuration.

Operating Notes

In software release K.13.01, DNS addressing is not configurable from a

DHCPv6 server.

8-11

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General