IPv6 Addressing Configuration
View IPv6 Gateway, Route, and Router Neighbors
ProCurve(config)# show ipv6 route
IPv6 Route Entries
Dest : ::/0
“Unknown” Address
Type : static
Gateway : fe80::213:c4ff:fedd:14b0%vlan10 Dist. : 40 Metric : 0
Dest : ::1/128
Loopback Address
Type : connected
Gateway : lo0 Dist. : 0 Metric : 1
Dest : 2001:db8:a03:e102::/64
Global Unicast Address
Type : connected
Gateway : VLAN10
Configured on the Switch
Dist. : 0 Metric : 1
Dest : fe80::%vlan10
Link-Local Address
Type : connected
Gateway : VLAN10
Configured on the Switch
Dist. : 0 Metric : 1
Dest : fe80::1%lo0 Type : connected
Link-Local Address Assigned
Gateway : lo0
to the Loopback Address
Dist. : 0 Metric : 1
Figure 4-4. Example of Show IPv6 Route Output
Viewing IPv6 Router Information
Syntax: show ipv6 routers [ vlan < vid > ]
This command lists the switch’s IPv6 router table entries for
all VLANs configured on the switch or for a single VLAN. This
output provides information about the IPv6 routers from
which routing advertisements (RAs) have been received on the
switch.
vlan < vid >: Optional. Specifies only the information on IPv6
routers on the indicated VLAN.
Router Address: The IPv6 address of the router interface.
Preference: The relative priority of prefix assignments received
from the router when prefix assignments are also received on
the same switch VLAN interface from other IPv6 routers.
Interface: The VLAN interface on which the path to the router
exists.
4-30
To Next Page
Loading...
Need help?
General