To Next Page

To Previous Page

IPv6 Management Features

IP Preserve for IPv6

The show snmpv3 targetaddress command displays the configuration (including

the IPv4 or IPv6 address) of the SNMPv3 management stations to which

notification messages are sent.

ProCurve(config)# show snmpv3 targetaddress

snmpTargetAddrTable [rfc2573]

Target Name IP Address Parameter

------------------------- ---------------------- ---------------------------

1 15.29.17.218 1

2 15.29.17.219 2

PP.217 15.29.17.217 marker_p

PP.218 2620:0:260:211

:217:a4ff:feff:1f70 marker_p

An IPv6 address is

displayed on two lines.

Figure 5-9. “show snmpv3 targetaddress” Command Output with IPv6 Address

IP Preserve for IPv6

IPv6 supports the IP Preserve feature, which allows you to copy a configura-

tion file from a TFTP server to multiple switches without overwriting the IPv6

address and subnet mask on VLAN 1 (default VLAN) in each switch, and the

Gateway IPv6 address assigned to the switch.

To configure IP Preserve, enter the ip preserve statement at the end of the

configuration file that will be downloaded from a TFTP server. (Note that you

do not invoke IP Preserve by entering a command from the CLI).

5-23

HP PROCURVE 2910AL Specifications

General

HP PROCURVE 2910AL Configuration Guide

Other manuals for HP PROCURVE 2910AL