HP PROCURVE 2910AL - Additional Examples of Authorized Ipv6 Managers Configuration

IPv6 Management Security Features
Authorized IP Managers for IPv6
Additional Examples of Authorized IPv6 Managers
Configuration
Authorizing Manager Access. The following IPv6 commands authorize
manager-level access for one link-local station at a time. Note that when you
enter a link-local IPv6 address with the ipv6 authorized-managers command,
you must also enter a VLAN ID in the format: %vlan<vlan-id>.
ProCurve(config)# ipv6 authorized-managers
fe80::07be:44ff:fec5:c965%vlan2
ProCurve(config)# ipv6 authorized-managers
fe80::070a:294ff:fea4:733d%vlan2
ProCurve(config)# ipv6 authorized-managers
fe80::19af:2cff:fe34:b04a%vlan5
If you do not enter an ipv6-mask value when you configure an authorized IPv6
address, the switch automatically uses FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF
as the default IPv6 mask. Also, if you do not specify an access value to grant
either Manager- or Operator-level access, by default, the switch assigns Man-
ager access. For example:
ProCurve# ipv6 authorized-managers 2001:db8::a8:1c:e3:69
ProCurve# show ipv6 authorized-managers
IPv6 Authorized Managers
--------------------------
Address : 2001:db8::a8:1c:e3:69
Mask : ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
Access : Manager
If you do not enter a value for ipv6-mask in the ipv6 authorized-managers command, the default mask of
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF: is applied. The default mask authorizes only the specified station (see
“Configuring Single Station Access” on page 6-5).
Figure 6-11. Default IPv6 Mask
6-13