EasyManua.ls Logo

HP PROCURVE 2910AL - Page 120

HP PROCURVE 2910AL
194 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IPv6 Management Features
TFTP File Transfers Over IPv6
.
flash < primary | secondary >: Copies a software file stored
on a remote host to primary or secondary flash memory
on the switch. To run a newly downloaded software
image, enter the reload or boot system flash command.
pub-key-file: Copies a public-key file to the switch.
startup-config: Copies a configuration file on a remote
host to the startup configuration file on the switch.
Syntax:
copy <source > tftp < ipv6-addr > < filename > < pc | unix >
Copies (uploads) a source data file on a switch that is
enabled with TFTP server functionality to a file on the TFTP
server at the specified IPv6 address, where <source> is one
of the following values:
command-output < cli-command >: Copies the output of a
CLI command to the specified file on a remote host.
config < filename >: Copies the specified configuration file
to a remote file on a TFTP server.
crash-data < slot-id | master >: Copies the contents of the
crash data file to the specified file path on a remote host.
The crash data is software-specific and used to deter-
mine the cause of a system crash. You can copy crash
information from an individual slot or from the master
crash file on the switch.
crash-log < slot-id | master >: Copies the contents of the
crash log to the specified file path on a remote host. The
crash log contains processor-specific operational data
that is used to determine the cause of a system crash.
You can copy the contents of the crash log from an
individual slot or from the master crash log on the
switch.
event-log: Copies the contents of the Event Log on the
switch to the specified file path on a remote host.
flash < primary | secondary >: Copies the software file used
as the primary or secondary flash image on the switch
to a file on a remote host.
startup-config: Copies the startup configuration file in
flash memory to a remote file on a TFTP server.
running-config: Copies the running configuration file to
a remote file on a TFTP server.
5-18

Table of Contents

Other manuals for HP PROCURVE 2910AL

Related product manuals