Multicast Listener Discovery (MLD) Snooping
Displaying MLD Status and Configuration
The specific form of the command might look like this:
ProCurve# show ipv6 mld vlan 8 config
MLD Service Vlan Config
VLAN ID : 8
VLAN NAME : VLAN8
MLD Enabled [No] : Yes
Querier Allowed [Yes] : Yes
Port Type | Port Mode Forced Fast Leave Fast Leave
---- --------- + --------- ----------------- ----------
A13 100/1000T | auto No Yes
A14 100/1000T | auto No Yes
A15 100/1000T | auto No Yes
A16 100/1000T | auto No Yes
A17 100/1000T | auto No Yes
A18 100/1000T | auto No Yes
A19 100/1000T | auto No Yes
A20 100/1000T | auto No Yes
A21 100/1000T | auto No Yes
A22 100/1000T | auto No Yes
A23 100/1000T | auto No Yes
A24 100/1000T | auto No Yes
Figure 7-7. Example of an MLD Configuration for a Specific VLAN
The following information is shown, if the specified VLAN is MLD-enabled:
■ VLAN ID and name
■ whether MLD is enabled on the VLAN (default NO, but the information
for this VLAN will be listed only if MLD is enabled)
■ whether the switch is allowed to act as querier on the VLAN
7-16
To Next Page
Loading...
Need help?
General