To Next Page

To Previous Page

Terminology

DAD Duplicate Address Detection. Refer to “Duplicate Address Detection (DAD)”

on page 4-18.

Device Identifier The low-order bits in an IPv6 address that identify a specific device. For

example, in the link-local address 2001:db8:a10:101:212:79ff:fe88:a100/64, the

bits forming 212:79ff:fe88:a100 comprise the device identifier.

DoS Denial-of-Service.

EUI-64 Extended Unique Identifier. Refer to “Extended Unique Identifier (EUI)” on

page 3-14.

Manual Address

Configuration

Configures an IPv6 address by using the CLI to manually enter a static address.

Referred to as “Static Address Configuration” in this guide. See Static

Address Configuration, below.

MLD Multicast Listener Discovery. Refer to the chapter titled “Multicast Listener

Discovery (MLD) Snooping”.

MTU Maximum Transmission Unit. The largest frame size allowed on a given path

or device. Refer to “Path MTU (PMTU) Discovery” on page 2-16.

RA Router Advertisement. Refer to “Router Advertisements” on page 4-27.

SLAAC Stateless Address Autoconfiguration. Refer to “SLAAC (Stateless Automatic

Address Configuration)” on page 2-7.

Static Address A permanently configured IPv6 address, as opposed to an autoconfigured

address.

Static Address

Configuration

Configures an IPv6 address by using the CLI to manually enter the address

instead of using an automatically generated or DHCPv6-assigned address.

Same as “Manual Address Configuration”. See also Manual Address Config-

uration, above.

A-1

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General