HP PROCURVE 2910AL Configuration Guide

IPv6 Addressing
IPv6 Address Deprecation
Notes Preferred and valid lifetimes on a VLAN interface are determined by the router
advertisements received on the interface. These values are not affected by the
lease time assigned to an address by a DHCPv6 server. That is, lease expiration
on a DHCPv6-assigned address terminates use of the address, regardless of
the status of the RA-assigned lifetime, and router-assigned lifetime expiration
of a leased address terminates the switch’s use of the address. (The router-
assigned lifetime can be extended by receipt of a new router advertisement.)
Statically configured IPv6 addresses are regarded as permanent addresses,
and do not expire.
Related Information
■ RFC 2462: “IPv6 Stateless Address Autoconfiguration”
■ RFC 4291: “IP Version 6 Addressing Architecture”
3-26

HP PROCURVE 2910AL Specifications

General

Model	HP ProCurve 2910al
Switching Capacity	128 Gbps
Throughput	95.2 Mpps
Management	Web, CLI, SNMP
Jumbo Frame Support	Yes
Manageable	Yes
Power	100-240 VAC
Power Supply	Internal
Operating Temperature	0°C to 45°C (32°F to 113°F)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF
Features	IPv6, VLAN, QoS, ACLs
Operating Humidity	15% to 95% non-condensing
Uplink Ports	4
Power over Ethernet	Yes (PoE+ models available)