To Next Page

To Previous Page

IPv6 Addressing Configuration

View the Current IPv6 Addressing Configuration

■ DAD Attempts: Indicates the number of neighbor solicita-

tions the switch transmits per-address for duplicate

(IPv6) address detection. Implemented when a new

address is configured or when an interface with config-

ured addresses comes up (such as after a reboot). The

default setting is 3, and the range is 0 - 600. A setting of

“0” disables duplicate address detection. (Refer to “Dupli-

cate Address Detection (DAD)” on page 4-18.)

■ VLAN Name: Lists the name of a VLAN statically configured

on the switch.

■ IPv6 Status: For the indicated VLAN, indicates whether

IPv6 is disabled (the default) or enabled. (Refer to “Config-

uring IPv6 Addressing” on page 4-5.)

■ IPv6 Address/Prefix Length: Lists each IPv6 address and

prefix length configured on the indicated VLAN.

■ Expiry: Lists the lifetime status of each IPv6 address listed

for a VLAN:

• Permanent: The address will not time out and need

renewal or replacement.

• date/time: The date and time that the address expires.

Expiration date and time is specified in the router

advertisement used to create the prefix for automati-

cally configured, global unicast addresses. The Address

Status field in the show ipv6 command output indicates

whether this date/time is for the “preferred” or “valid”

lifetime assigned to the corresponding address. (Refer

to “Preferred and Valid Address Lifetimes” on page 3-

25.)

4-24

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General